Building with Debug Symbols

First make sure srsRAN has been downloaded, and you have created and navigated to the build folder:

git clone
cd srsran
mkdir build
cd build

To build srsRAN with debug symbols, the following steps can be taken. If srsRAN has already been built, the original build folder should be cleared before proceeding. This can be done with the following command:

rm -rf *
make clean

The following command can then be used to build srsRAN with debug symbols enabled:

cmake -DCMAKE_BUILD_TYPE=RelWithDebInfo ../
make test

The log file containing the debug info can be found in the srsran_backtrace.log file.

Examining PCAPs with Wireshark

The srsRAN applications support packet capture at the MAC and NAS layers of the network stack.

Packet capture files (pcaps) can be viewed using Wireshark ( pcaps are encoded in compact MAC-LTE and MAC-NR form. They can be found in the /tmp folder where other logs are located. To view in wireshark, edit the preferences of the DLT_USER dissector.

To decode MAC pcaps add an entry with the following:

  • DLT=149

  • Payload Protocol=udp

Further, enable the heuristic dissection in UDP under: Analyze > Enabled Protocols > MAC-LTE > mac_lte_udp and MAC-NR > mac_nr_udp

Using the same filename for mac_filename and mac_nr_filename writes both MAC-LTE and MAC-NR to the same file allowing a better analysis.

To decode NAS pcaps add and entry with the following:

  • DLT=148

  • Payload Protocol=nas-eps

For more information, see

The srsEPC application supports packet capture (pcap) of S1AP messages between the MME and eNodeBs. Enable packet captures in epc.conf or on the command line, by setting the pcap.enable value to true. To view in wireshark, edit the preferences of the DLT_USER dissector.

To decode S1AP pcaps add an entry with:

  • DLT=150

  • Payload Protocol=s1ap